After the initial review of the Dell/ Silicom PEG6I six port Gigabit Ethernet adapter came up, where I showed that a simple search could yield six Intel Gigabit Ethernet ports on one card for under $125 (see here for the PEG6I eBay search), I turned to look at the PEG6I’s VMware ESXi 5.0 compatibility which was good. I did want to take the opportunity to show how VMware ESXi 5.0 VMDirectPath pass-through works on this multi- gigabit Ethernet port card. The behavior of this is that the Dell/ Silicom PEG6I can be passed through in pairs of ports as can be seen below:
As one can see I am actually using an Opteron 6128 platform here hence the ATI Technologies Inc RD890 root seen in VMware ESXi 5.0. The Dell/ Silicom PEG6I has the 42:00.0 and 43:0x:0x roots in the above picture. That ESXi 5.0 warning message shows that selecting one network interface, (e.g. the 44:00.o network interface) for ESXi 5.0 pass-through also requires a dependent device to be passed (e.g. the 44:00.1 network interface.) This behavior is the same with Intel’s VT-d as well as ATI’s IOMMU with VMware ESXi 5.0 VMDirectPath. Bottom line is that one can only pass pairs of NICs through, which is not an uncommon feature. This is means for the for the approximately $125 (see here for the PEG6I eBay search) street price, one can pass through pairs of NICs to three different VMware virtual machines. It is also a reason that using Intel 82574L Ethernet controllers on motherboards is very popular because one can pass each 82574L independently through to VMs.
Just wanted to thank you for your original article on these. My home lab is very much happier with the extra ports, and seeing this postjust makes it better.
This behavior is expected since each 82571EB controller provides two ports, the Dell PEG6i has 3 82571EB controllers and VMDirechPath can only passthrough the entire controller to the VM. So, for each controller passed through, the VM will receive direct control of two ports.
I just get this card but I find it can passthrough uder ESX. It seem that the PCI-E bridge don’t support ACS.
The price of these on ebay is through the roof now.
I am having an issue with the PEG6i card on ESXi 5.5u2 with a Tyan (S7002) motherboard. You can tag the port pairs for passthrough, but they don’t become available after the required restart. It just keeps requesting a host restart to become available.
Done the typical… latest BIOS, updates, PCIe slot changes, etc. Basically everything short of changing hypervisors. Stumped.